Table of Contents
Advertisement
4.
Install the discharge deflector onto the right side
of the deck using the hex head bolts, flat washers
and locknuts and removed in step 3 above
(Fig. 31).
1
Figure 31
1. Discharge Deflector
2. Hex Head Bolt (2)
5.
Loosen the wing nut on the front cover shaft
(Fig. 32).
6.
Lift the tab on the end of the slot cover up and
out of the slot in the deck, then rotate the slot
cover 180 degrees (Fig. 32).
2
3
m–2687
4
3. Locknut (2)
4. Flat Washer (2)
1
2
Figure 32
1. Slot Cover
2. Tab
7.
Slide the wing nut and front cover shaft to the
"OPEN" position on the deck to swing the front
cover to the side discharge position (Fig. 33).
8.
Insert the tab on the end of the slot cover back
into the slot in the deck (180 degrees from its
original position), then tighten the wing nut on
the front cover shaft (Fig. 33).
1
Figure 33
1. Wing Nut and Front Cover
Shaft (in "OPEN" position)
Maintenance
3
m–2688
3. Wing Nut on Front Cover
Shaft (in "CLOSED"
position)
3
2
m–2692
2. Slot Cover
3. Tab
21
Advertisement
Table of Contents
