Table of Contents
Advertisement
Maintenance
Inspecting the Blades
1.
Inspect the cutting edges (Fig 14). If the edges
are not sharp or have nicks, remove and sharpen
the blades. Refer to Sharpening the Blades on
page 15.
2.
Inspect the blades, especially the curved area
(Fig. 14). If you notice any damage, wear, or a
slot forming in this area (item 3 in Fig. 14),
immediately install a new blade.
Figure 14
1. Cutting Edge
2. Curved Area
14
1
2
3
m–151
3. Wear/slot Forming
Checking for Bent Blades
1.
Rotate the blades until the ends face forward and
backward (Fig. 15). Measure at the "C" locations
from a level surface to the cutting edge of the
blades (Fig. 16). Note this dimension.
Figure 15
Figure 16
2.
Rotate the opposite ends of the blades forward.
Measure from a level surface to the cutting edge
of the blades at the same position as in step 1
above. The difference between the dimensions
obtained in steps 1 and 2 must not exceed 1/8"
(3 mm). If this dimension exceeds 1/8" (3 mm),
the blade is bent and must be replaced. Refer to
Removing the Blades, and Installing the Blades
on page 15.
m–2624
m–2626
Advertisement
Table of Contents
