Table of Contents
Advertisement
Figure 22
1. Spring-loaded idler pulley
2. Short-hook end
5. Pull the spring-loaded idler pulley back and route the
belt around the mower deck pulley
Note: Ensure the belt is routed around the blower
pulleys correctly
Figure 23
1. Mower deck pulley
2. Spring-loaded idler pulley
3. Long-hook end
(Figure
23).
3. Blower assembly
7
Adjusting the Flow Baffle
No Parts Required
Procedure
1. Swing the lever up to loosen the cam lock
2. Align the flow baffle and cam lock in the slot to the
edge of the blower assembly.
3. Swing the lever back over to tighten the baffle and cam
lock
(Figure
24).
4. If the cam does not lock the baffle into place or it is
too tight, loosen the lever and then rotate the cam lock.
Note: Adjust the cam lock until you achieve the
desired locking pressure.
1. Cam lock
2. Lever
12
(Figure
Figure 24
3. Rotate cam to increase or
decrease locking pressure
4. Slot
24).
Advertisement
Table of Contents
