Table of Contents
Advertisement
The list of parameters (in the sequence in which they are dis-
played) is shown in Tab. P.
No.
Parameter
Volumetric delivery of fuel in the unit of measurement
167
selected
162
Operation time with flame
163
Operation time
164
No. of resettable ignitions
165
No. of ignitions
Fuel 1: Volumetric output of fuel in the unit of meas-
177
urement selected
172
Fuel 1: Operation time with flame
174
Fuel 1: No. of resettable ignitions
175
Fuel 1: No. of ignitions
166
Total no. of ignitions
113
Identification code of the burner
107
Software version
108
Software variation
102
Control box test date
103
Identification code of the control box
104
Identification number of the group of parameters set
105
Version of the group of parameters
143
Reserved
End
6.8.3
Service mode
The Service mode (SEr) visualises the error log and certain
technical information about the system. To access this level you
must:
press the "i/reset" key for more than 3 s.
Release the key immediately when the display shows
"SEr".
P
/reset
The list of parameters (in the sequence in which they are dis-
played) is shown in Tab. Q.
No.
Parameter
954
Flame intensity (%)
960
Actual fuel which passes in units of volume / h
(m³/h, l/h, ft³/h, gal/h)
121
Manual setting of output
Not defined = automatic operation
922
Position of the servomotors (expressed in de-
grees, symbol
0 = fuel
1 = air
161
Number of errors
701 ÷725
Log of the errors: 701-725.01, Code
945
Fuel in use:
0 = fuel 0 (oil)
1 = fuel 1 (gas)
Start-up, calibration and operation of the burner
Tab. P
h
s
V
min
%
)
Tab. Q
6.8.3.1 Operating mode on Info Mode and Service Mode
After access to these levels, the display visualises the number of
the parameter (flashing) on the left, and the corresponding value
on the right.
P
If the value is not displayed, press the "i/reset" key for a period
of 1 to 3 seconds
To return to the Parameter List, press the "i/reset" key for more
than 3 s, or press the keys "+" and "-" (ESC) simultaneously.
To move on to the next parameter, press the key "+" or "i/reset"
for less than 1s. At the end of the list, the display visualises
"End".
To move back to the previous parameter, press the key "-".
To return to the Normal/Standard Visualisation Mode, press the
"i/reset" key for more than 3 s, or press the keys "+" and "-"
(ESC) simultaneously.
For a moment the display will show "OPErAte".
6.8.4
Parameters Mode
The Parameters Mode (PArA) displays and allows you to modi-
fy/programme the parameters list on page 47.
The factory-set parameters are not visible.
To access this level, refer to "Access procedure with pass-
word".
6.8.4.1 Access procedure with password
Press the "F" and "A" keys simultaneously for 1s.
For a moment the display will show "CodE", and immediately af-
ter you will see 7 dashes, the first one flashing.
VSD
F
A
With the keys "+" and "–" select the first character of the pass-
word (letter or number), and confirm by pressing the key "i/re-
set".
39
GB
h
min
s
%
P
V
h
min
P
V
h
min
P
V
h min s
%
s
%
s
%
/reset
20121288
Advertisement
Table of Contents
