Cycle Selection Charts - Kenmore ULTRA WASH 665.1379 Series Use & Care Manual

Hide thumbs Also See for ULTRA WASH 665.1379 Series:
Table of Contents

Advertisement

Select the wash cycle and options desired. Or press START/
RESUME to use the same cycle and options as the previous
cycle.
NOTE: If the last cycle you completed was a rinse cycle, the
dishwasher will run the last full wash cycle and options that you
selected when you press START/RESUME.
A " " shows the steps that are in each cycle.
Water usage is shown in U.S. gallons/liters.
These models meet the ENERGY STAR
efficiency.
Cycle time includes dry time. An asterisk ( * ) by the cycle time,
Main Wash, and Final Rinse indicates the cycle time might be
longer depending on the temperature of the water entering the
dishwasher.
IMPORTANT: These sensor-based cycles may take several
hours depending on cycle selected, water temperature, soil level,
and dish mass sensed.
Smart Wash
Use this cycle for all day-to-day soil types when washing full to
partial dish loads. During the cycle, the sensors will determine
water temperature, wash time, and water amount based on the
soil level and the dish load size. During the main wash, the wash
action will repeatedly pause for several seconds.
Use both detergent dispenser sections when
washing a full soiled dish load.
Use one detergent dispenser section when
washing lightly soiled, partial dish loads.
Dish
Soil
Pre-
Main
load
Level
Wash
Wash*
Sensed
Heavy
145ºF
(63ºC)
Nominal
Full
119ºF
(48ºC)
Light
115ºF
(46ºC)
Heavy
145ºF
(63ºC)
Nominal
Partial
119ºF
(48ºC)
Light
115ºF
(46ºC)

Cycle Selection Charts

®
guidelines for energy
Rinse
Final
Dry
Average
or
Rinse*
Time*
Purge
(min)
145*
Rinse
140ºF
25.0-28.4
(60ºC)
115*
Purge
140ºF
(60ºC)
105*
Purge
140ºF
(60ºC)
130*
Purge
140ºF
21.2-24.6
(60ºC)
105*
Purge
140ºF
(60ºC)
105*
Purge
140ºF
(60ºC)
Pots Pans
Use this cycle for heavily soiled pots, pans, casseroles, regular
tableware and hard** water conditions.
Use both detergent dispenser sections.
Pre-
Main
Wash
Wash*
140°F
(60°C)
Normal Wash
Use this cycle for loads with normal amounts of food soil. (The
energy-usage label is based on this cycle.) During the wash
cycle, the wash action will repeatedly pause for several
seconds.
Use both detergent dispenser sections.
Pre-
Main
Wash
Wash*
115°F
(46°C)
Fast Wash
Use this cycle for a quick wash to clean dishes prior to
entertaining. Towel drying may be needed. This cycle takes
exactly 30 minutes.
Water
Use main detergent dispenser section.
Usage
(gal/L)
Pre-
Main
6.6-7.5/
Wash
Wash
5.6/21.2
†A small amount of water is run through the pump to remove
4.3/16.3
soil particles between the main wash and final rinse.
*If the incoming water temperature is less than the
5.6-6.5/
recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat, and water
as needed.
5.6/21.2
**Hard water is defined as 7 grains per U.S. gallon and above.
NOTE: The sensor in your dishwasher monitors the soil level.
4.3/16.3
Cycle time and/or water usage can vary from the numbers above
as the sensor adjusts the cycle for the best wash performance.
Pre-
Final
Dry
Average
Rinse†
Rinse*
140°F
(60°C)
Pre-
Final
Dry
Average
Rinse†
Rinse*
140°F
(60°C)
Pre-
Final
Dry
Rinse†
Rinse
Water
Time*
Usage
(min)
(gal/L)
125*
6.9-7.8/
26-30
Water
Time*
Usage
(min)
(gal/L)
110*
4.3-7.8/
16-30
Time
Water
(min)
Usage
(gal/L)
30
6.9/26
15

Advertisement

Table of Contents
loading

Table of Contents