Biostar PT890 775 SE Setup Manual page 92

DRAM Clock/Drive Control
This item controls the DRAM Clock. Highlight "Press Enter" next to the
" DRAM Clock/Drive Control" label and pressing the enter key will take you a
submenu with the following options:
Figure 9.1: DRAM Clock/Drive Control
DRAM Clock
This item determines DRAM clock.
The Choices: B y SPD (default), 100MHz, 133MHz,166MHz, 200MHz,
266MHz .
DRAM Timing
This item determines DRAM clock/ timing.
The Choices: Auto by SPD (default), Manual.
SDRAM CAS Latency
When DRAM is installed, the number of clock cycles of CAS latency depends
on the DRAM timing.
The Choices: 2.5/4(default), 1.5/2, 2/3, 3/5.
Bank Interleave
This item allows you to enable or disable the bank interleave feature.
PT890 775 SE
38