Download Table of Contents Print this page

Power Source - NEC E461 User Manual

46" entry-level commercial-grade large-screen display w/ integrated tuner
Hide thumbs Also See for E461:


Table of Contents
antenna system is grounded to protect against voltage surges and built
up static charges. Section 810 of the National Electric Code, ANSI/NFPA
No. 70-1984, provides information with respect to proper grounding
for the mast and supporting structure, grounding of the lead-in wire
to an antenna discharge unit, size of grounding connectors, location
of antenna discharge unit, connection to grounding electrodes and
requirements for the grounding electrode.
To the display system installer: This reminder is provided to call
attention to Article 820-44 of the National Electric Code that provides
guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the facility, as
reasonably close to the point of cable entry as possible

Power source

This LCD display operates on 120 volts 60 Hz, AC current. Insert the power
cord into a 120 volts 60 Hz outlet. The mains plug is used as the disconnect
device and shall remain readily operable.
To prevent electric shock from the display, do not use with an extension cord,
receptacle, or other outlet unless the blades and ground terminal can be fully
inserted to prevent blade exposure.
Never connect the LCD display to 50 Hz, direct current, or anything other than
the specified voltage.
Never remove the back cover of the LCD display as this can
expose you to very high voltages and other hazards. If the display does not
operate properly, unplug the LCD display and call your authorized dealer or
service center.
Adjust only those controls that are covered in the instructions, as improper
changes or modifications not expressly approved by NEC could void the
user's warranty.


Table of Contents

This manual is also suitable for:


Table of Contents