Important Safety Instructions - NEC E461 User Manual

Important Safety Instructions

Read before operating equipment
Follow all warnings and instructions marked on this display.
1. Read and keep these instructions.
2. Obey all warnings.
3. Follow all instructions.
4. Do not use equipment near water.
5. Clean with dry cloth.
6. Do not block any of the ventilation areas. Install in accordance with the
manufacturer's instructions.
7. Do not install near heat sources, including radiators, heat registers,
stoves, or any other apparatus that creates heat.
8. Do not alter the safety purpose of the polarized or grounding type
plug. The polarized plug has two blades, one wider than the other. A
grounding type plug has two blades and a grounding prong. The wide
blade or the third prong on each plug type is provided for your safety. If
the provided plug does not fit into an outlet, consult an electrician.
9. Protect the power cord from being stepped on or pinched. Pay close
attention to the connections at the wall, and the point where the cord
exits from the display.
10. Only use the attachments/accessories as indicated by the manufacturer.
11. Use only with the cart, stand, tripod, bracket, or table as instructed
by the manufacturer or sold with the device. When a cart is used, be
cautious of mishaps that cause injury.
12. Unplug during lightning storms or when idle for long periods of time.
13. Refer all service issues to a qualified NEC technician. Service may be
necessary when the display is damaged in any way, including harm to
the power cord and plug, if liquid touches the display, if the display is
dropped, or if the display does not operate properly.
14. The display complies with the recommended safety standards for
stability. Do not excessively put force on the front or top of the cabinet.
This could cause the product to tip over and cause damage and/or
personal injury.
15. Follow instructions for wall, shelf or ceiling mounting as recommended
by the manufacturer.
16. An outdoor antenna should not be located near overhead power lines or
any electrical circuits.
17. If an outside antenna is connected to the receiver, confirm that the
S3125A
English-2