Installation Of Molded Brick Panel; Install The Refractory - Outdoor Lifestyles ODCASTLEWD-42-B Owner's Manual

7 7

Installation of Molded Brick Panel

A. Install the Refractory
We recommend two installers for hearth stone and refrac-
tory installation!
Note: Before installing refractory, be sure all back edges
of each piece are smooth to ensure proper fit. Scrape
away excess with a regular screwdriver. See Figure 7.1.
Figure 7.1 Scrape Away Rough Edges
• Remove screen rods. (Locate screw holding each rod
and remove.)
• Remove smoke shield. (Remove the (5) screws holding
the shield.)
• Set back refractory into place, making sure refractory
is centered and notches are to the bottom of firebox.
• Place grate brackets in outer two notches of refractory.
See Figure 7.2.
• Secure back refractory in place with screws and bracket
supplied in hardware package.
Grate Brackets
Figure 7.2 Grate Brackets In Place
20 Outdoor Lifestyles by Hearth & Home Technologies Inc. • ODCASTLEWD-42-B • 4070-160 Rev A • 10/22
Side Refractory
Retainer
Left Side
Molded Brick
Panel
Hearth
Figure 7.4
• Tilt top of side refractory towards center of firebox when
placing it into fireplace. Push side refractory towards back
corner of fireplace until it fits tightly against back refractory.
• Secure side refractory in place with screws and bracket
provided in the hardware package.
• Repeat these two steps for installation of the other side
refractory.
• Place grate into grate brackets. See Figure 7.3.
• Replace smoke shield.
• Replace left and right screens.
• See section B for installing screens.
Figure 7.3 Grate Secured In Grate Bracket
Back Refractory Retainer
Back Molded Brick Panel
Grate
Retainer
Right Side Molded
Brick Panel
Side Refractory
Retainer