Table of Contents
Advertisement
If you have any questions about how to install, operate or
service the fixture safely, please contact your Martin™ distributor
(see www.martin.com/where-to for details) or call the Martin™
24-hour service hotline on +45 8740 0000, or in the USA on 1-
888-tech-180.
Respect all locally applicable laws, codes and regulations when
installing, operating or servicing the fixture.
Protection from electric shock
Do not expose the fixture to rain or moisture.
Disconnect the fixture from AC power before carrying out any
installation or maintenance work and when the fixture is not in
use.
Ensure that the fixture is electrically connected to ground (earth).
Use only Neutrik PowerCon cable connectors to connect to the
fixture's power sockets.
Use only a source of AC power that complies with local building
and electrical codes and has both overload and ground-fault
(earth-fault) protection.
Socket outlets or external power switches used to supply the
fixture with power must be located near the fixture and easily
accessible so that the fixture can easily be disconnected from
power.
Isolate the fixture from power immediately if the power plug or
any seal, cover, cable, or other component is damaged,
defective, deformed, wet or showing signs of overheating. Do
not reapply power until repairs have been completed
Before using the fixture, check that all power distribution
equipment and cables are in perfect condition and rated for the
electrical requirements of all connected devices.
Do not connect devices to power in a chain that will exceed the
electrical ratings of any cable or connector used in the chain.
The mains power input cable supplied with the fixture is rated to
supply only one fixture with mains power. Do not connect any
device to the fixture's MAINS OUT socket when using this input
cable. If you want to connect other fixtures to the MAINS OUT
socket, see 'Linking fixtures to power in a chain' on page 12.
Advertisement
Table of Contents
