How To Remove The Oven Door; How To Replace The Oven Lamp - Whirlpool AKZ 162/WH Instructions For Use Manual

31002015GB.fm Page 11 Friday, November 21, 2008 5:39 AM
Attention: When carrying out the following operations it
is advisable to wear protective gloves. These instructions
should be followed carefully both to prevent injury and in
order to avoid damaging the oven door or hinges.

How to remove the oven door:

1. Open the oven door fully (see fig. 1).
2. Lift the two catches and push them forwards as far as they
go (see fig. 2).
3. Remove the door by closing it partially and lifting it upwards
(see fig. 3).
To refit the door:
1. Insert the hinges into their grooves and lower the door fully.
2. Lower the two catches.
3. Close the oven door fully.
Attention: These instructions should be followed carefully both
to prevent injury and in order to avoid damaging the oven door
or hinges.
Lowering the top oven grill element to clean the oven roof
Lowering the bottom oven grill element to clean the oven
roof (depending on the model)
• Do not attempt to clean the oven until it is cool.
1. To clean the oven roof, pull out the grill element and lower
it as far as it will go.
2. Clean the oven roof and then return the grill element to its
original position.

HOW TO REPLACE THE OVEN LAMP

1. Switch off electricity at the mains.
2. Unscrew the lamp cover.
3. Replace the bulb.
4. Refit the lamp cover.
5. Switch on the power again at the mains.
Note:
Use only a replacement bulb of 25 Watts 230 V, Type E-14,
T300°C, available from our After Sales Service.
Important: Do not use the oven until the lamp cover has
been repositioned.
11