Care And Maintenance; Switching The Appliance Off; Cleaning The Appliance; Cleaning The Oven Door - Whirlpool FT850P.1 Operating Instructions Manual

Care and maintenance

Switching the appliance off

GB
Disconnect your appliance from the electricity
supply before carrying out any work on it.

Cleaning the appliance

! Never use steam cleaners or pressure cleaners on
the appliance.
• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.

Cleaning the oven door

Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack. For more thorough cleaning purposes, the
oven door may be removed:
22
1. Open the oven door fully
( see diagram ).
2. Lift up and turn the small
levers located on the two
hinges ( see diagram ).
3. Grip the door on the two
external sides and close it
approximately half way. Pull
the door towards you, lifting it
out of its slot ( see diagram ).
To replace the door, reverse
this sequence.
! Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
Inspecting the seals
Check the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
After-sales Service Centre. We recommend that the
oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:
Oven
compartment
Lamp
Seal
Glass door
1. Remove the glass cover using a screwdriver.
2. Remove the light bulb and replace it with a similar
one: Wattage 15 W, cap E 14.
Replace the glass cover, making sure the seal is
positioned correctly ( see diagram ).
Automatic cleaning using the FAST
CLEAN function
With the FAST CLEAN mode, the internal
temperature of the oven reaches 500°C. The
pyrolytic cycle is activated, burning away food and
grime residues. Dirt is literally incinerated.
Keep children away from the appliance during the
automatic cleaning cycle as surfaces may become
very hot. Particles may ignite inside the oven due to
the combustion process.