Table of Contents
Advertisement
USING YOUR OVEN
PILOT IGNITION
OVEN DOOR
DESIGN2
-
SPECIAL D OOR
Be sure oven control is set in the OFF
When opening oven door, allow steam
On some models, the oven door is
equipped with a special hinge that locks
position priorto supplying gas to the ap-
and hot air to escape before reaching in
pliance,
oven to check, add or remove food.
into place as the door is removed.
To light oven pilot: When cool, remove
To remove door with special hinges:
oven racks and oven bottom. With the
1. Open door to the broil stop position
oven thermostat knob in the OFF posi-
(open about 4 inches).
tion, hold a lighted match to the pilot lo-
cated at the back end of the oven
2. Grasp the sides of the door at the
burner. Once pilot lights, replace oven
middle of the door. Slowly lift door
bottom and racks,
straight up.
3. As you lift the door up, very slightly
l
'__
Your wall oven will feature either the
open door by pulling door toward
standard door (Design 1) or a door with
you. Check to be sure latches (A)
special hinges (Design 2).
swing down into the notches on the
hinge arms.
DESIGN1
- STANDARD DOOR
To remove door: Open door to the
"stop" position (opened about 4 inches)
and grasp door with both hands at each
side. Do not use door handleto lift door.
Lift up evenly until door clears the hinge
arms.
PILOTLESS IGNITION
GIo bar-type ignition
_._
_
With this type of ignition system, the
ovenwill not operate during a power fail-
I
ure or if unit is disconnected from the
wall outlet. No attempt should be made
to operate oven during a power failure.
To replace door:
1. Grasp sides ofdoor and align slots in
OVEN BURNER
door with hinge arms.
The size and appearance of a properly
adjusted oven burner flame should be
2. Very slightly pull door to a more
as shown:
open position as you slide the door
down onto the hinge arms. The slid-
ing action of the door will disengage
the latches on the hinge arms.
L_
3. Gently push the door downward until
F'
the door rests evenly on the hinges.
--_
---
Close door.
Cone in center is smaller
q
_
To replace door: Grasp door at each
L
side, align slots in the door with the
;.
-t
Cone approx. 1/2-inch
hinge arms and slide door down onto
the hinge arms until completely seated
on hinges.
-6-
Advertisement
Table of Contents
