Troubleshooting Guide; After Sales Service - Whirlpool AKZ 162/WH Instructions For Use Manual

31002015GB.fm Page 12 Friday, November 21, 2008 5:39 AM

TROUBLESHOOTING GUIDE

Oven not working:
• Check there is mains power and that the oven is
connected to the power supply.
• Switch the oven off and then back on again to see
if the fault persists.

AFTER SALES SERVICE

Before contacting After Sales Service:
1. Try to solve the problem yourself following the
points described in "Troubleshooting Guide".
2. Switch the appliance off and then back on again
to see if the fault persists.
If after the above checks the oven or cooktop
are still not working properly, contact the
nearest After Sales Service.
Please give:
•A short description of the fault;
•the oven type and model;
•the service number (number after the word
Service on the rating plate), located on the
right hand edge of the oven cavity (visible
when the oven door is open). The service
number is also indicated on the guarantee
booklet;
•your full address;
•your phone number.
12
IMPORTANT:
• Check that the oven control knob is not turned
to "0" or to the "lamp" symbol
- If the electronic programmer (depending on
model) display presents the message
" ", press the button 2 to reset the oven
and then set the clock (see the Programmer
Description Sheet supplied separately).
- If the electronic programmer (depending on
the model) presents the message "F XX",
contact the nearest After Sales Service.
Specify in this case the number that follows
the letter "F".
- Check that the mechanical programmer
(if provided) is turned to "manual".
In the event the oven must be repaired, contact an
authorised After Sales Service, (use of original
replacement parts and proper repair is guaranteed).
Failure to comply with these instructions may
compromise the safety and quality of the
product.
DECLARATION OF CONFORMITY
• This oven is suitable for contact with
foodstuffs and complies with EEC (CE)
Regulation n. 1935/2004.
• This appliance is designed to be used for
cooking only.
Any other use (for example, for room
heating) is considered as improper use and
potentially dangerous.
• The appliance was designed, manufactured
and sold in compliance with:
- safety objectives of the "Low Voltage"
Directive 2006/95/CE (which replaces
73/23/CEE and subsequent
amendments);
- the protection requirements of EMC
Directive 89/336/EEC
- the requirements of Directive 93/68/EEC.
.