Programming Additional Remote Controls - Genie Pro Series Installation, Programming, & Operation

PROGRAMMING ADDITIONAL REMOTE CONTROLS

THE REMOTE CONTROLS INCLUDED WITH THIS
OPENER HAVE BEEN
PROGRAMMED AT THE FACTORY FOR YOUR
CONVENIENCE.
NOTE: The following instructions are for remote control transmitters purchased
separately (In addition to those provided with this opener) but can also be used
if remote(s) require re-programming.
NOTE: Each programming step has a 30 second time limit for completion
after the function is initiated. After 30 seconds, two LED's will illuminate RED
indicating time has expired and the step must be re-started. Restart the step
as many times as necessary to complete the programming.
NOTE: Each button on each remote must be programmed separately,
following these steps.
1. Remove the battery's protective film from the remote
by pulling straight down.
2. Press and hold the SET/PRGM button on the
opener for 2-5 seconds.
The ROUND LED will turn BLUE. Release button.
The LONG LED will then flash PURPLE.
3. Stand at least 5 feet away from opener and slowly
press and release the desired button on the remote
two times.
Both opener LEDs will flash and turn off indicating the
remote has been programmed.
4. Press the desired remote button again.
The opener should run.
To program the same remote for other garage door openers,
repeat the steps above using one of the other remaining
remote buttons.
REPEAT STEPS 1 TO 4 FOR EACH OPENER AND REMOTE
NOTE: It is possible to press the remote button too quickly or lightly.
If the LEDs do not go off, press the remote button several more times
to achieve confirmation.
BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE DOOR
OPENER IS READY TO USE.
See page 28 of this manual to erase remote devices from
memory.
1. Activate Remote
2. Enter Programming Mode
Solid Blue
Flashing Purple
3. Press Remote Button Twice
Flashing
4. Test Remote
PRESS
&
RELEASE
21