Wall Console - Overview; Optional Dual Wall Console - Installation - Genie Garage Door Opener Programming Manual

This opener has a Serial Number sticker in which the serial
numbers begin with 10 or higher.
ATTENTION
If your garage door opener has a Serial Number sticker which
looks like this, in which the first two numbers are 10 or higher,
your opener will operate using this Series III wall control.
MODEL AC SR3
FCC ID: B8Q AC SR3
IC: 2133A-CSD1D
S/N:10XXXXXXXXXXXX
FOR HELP CALL 1-800-35GENIE OR WWW.GENIECOMPANY.COM
Follow the instructions on this page.
Use the wall console supplied with this opener. Other
Genie® wall consoles may be available for upgrade. Confirm
compatibility prior to installing as some wall consoles may
not operate this opener properly. Wall consoles from other
manufacturers may not work with this opener.

WALL CONSOLE - OVERVIEW

Use only the Series III wall console provided with this
unit.
Wall console has three buttons and one indicator light.
Indicator Light
Indicator light will display Red when wall console is
properly wired and Sure-Lock™ is OFF. When Sure-
Lock™ is ON indicator light flashes.
Open/Close Button
Use this button to open or close garage door. When
Sure-Lock™ is ON the Open/Close button will CLOSE
door only. Note: Constant button pressure in the
CLOSE mode will override error responses in the
powerhead and close door.
Independent Light Control Button
Use this button to turn powerhead lights ON.
Powerhead lighting will remain ON until this button
is pressed again or a door action has been completed.
Note: If opener has a Motion Detector sensor the
sensor will keep powerhead lights ON as long as
motion is detected.
Sure-Lock™ Button
When Sure-Lock™ is ON the powerhead cannot be
activated by the wall console or a remote.
• Press and hold for 5 seconds (or until Indicator
Light flashes) to activate Sure-Lock™.
• Press and release to turn Sure-Lock™ OFF.
20
THE GENIE COMPANY
Residential Door Operator
120V. 60HZ. 5A
©2011 The Genie Company
Open/Close Button
Open and closes door from inside garage
Sure-Lock™ Button
– LOCK disables controls
after door is completely
closed
– UNLOCK allows controls to
work normally
Indicator Light
Red indicator light is always ON
When Sure-Lock™ is ON the
indicator light flashes
Independent Light Control Button
Controls door opener lights from inside garage
Tip: If indicator light on wall console comes ON, but
there is NO
FROM STBs OM STBs
operation from
buttons - verify
wall console
wire routing
at powerhead
connector.

OPTIONAL DUAL WALL CONSOLE - INSTALLATION

Use only a Series III wall console when adding a
second wall console. The optional second Genie®
Series III wall console must be purchased separately.
POWERHEAD
FROM STBs
FROM WALL
CONSOLE
NOT NOT NOT NOT
USED USED USED USED
STB BWC IWC
Wire connector
on Powerhead
FROM STBs
FROM WALL
CONSOLE #1
FROM WALL
CONSOLE #2
NOT NOT
USED USED
STB BWC IWC
Wire connector on
Powerhead
FROM STBs
FROM WALL ROM WA OM W
CONSOLE ONSO OLE
STB STB BWC BWC IWC IWC
STB
TO
TO WALL CONSOLE #1
B/ W
W
WALL
CONSOLE #2
CONSOLE #1
OR
BOTH TO POWERHEAD
B/ W
W
WALL
CONSOLE #1
3/2011
FROM WALL
CONSOLE
NOT NOT NOT NOT
USED USED USED USED
BWC IWC
W
B/ W
WALL
W
B/ W
WALL
CONSOLE #2