Advertisement
English
Setup
To set up the printer, follow the steps below.
1. Removing the protective materials and tape (
2. Connecting the cables (
3. Attaching the connector cover (
4. Installing the ribbon cartridge (
5. Installing the roll paper (
6. Test printing (
U
7. Attaching the power switch cover (
8. Applying the LED information label (
Notes:
Q
When using the printer, be sure to install roll paper.
For models with the MICR reader, do not place the printer near any magnetic fields to avoid decreasing the
MICR recognition rate. In particular, when you install the printer near a CRT display device, check the
recognition rate of the MICR reader.
U
"Connecting the Cables" on page 9
U
U
"Attaching and Removing the Connector Cover" on page 11
U
"Installing and Replacing the Ribbon Cartridge" on page 12
"Installing the Roll Paper" on page 17
U
)
"Test Printing" on page 19
U
"Attaching the Power Switch Cover" on page 19
U
"Applying the LED Information Label" on page 20
"Removing the Protective Materials and Tape" on page 8
)
)
)
)
)
)
)
7
Advertisement
