MultiPlus-II inverter/charger off-grid Australia
5.2.1. VictronConnect
The MultiPlus-II is configured using VictronConnect. More general information about the VictonConnect app - how to install it; how
to pair it with your device; and how to update firmware, for example - can be found by referring to the overall
VictronConnect
manual.
5.2.2. VEConfigure
All settings can be changed with a PC and free of charge software VEConfigure, downloadable from our website
www.victronenergy.com. See this manual for more information -
VEConfigure
5.2.3. VE.Bus Quick Configure Setup
VE.Bus Quick Configure Setup is a software program with which systems with a maximum of three Multis (parallel or three
phase operation) can be configured in a simple manner.
The software can be downloaded free of charge at www.victronenergy.com.
5.2.4. VE.Bus System Configurator
For configuring advanced applications and/or systems with four or more Multis, VE.Bus System Configurator software must be
used.
The software can be downloaded free of charge at www.victronenergy.com .
5.3. Firmware
It is not required to update the unit to the latest firmware version. Stable systems should be left with their current firmware.
For information on firmware and for instructions on how to view the firmware version refer to the
VictronConnect configuration
guide for VE.Bus products
document.
Page 12
Configuration