Introduction; The Battery Monitor; Why Should I Monitor My Battery; Sizing - Victron energy SmartShunt IP65 Manual

2. Introduction

2.1. The battery monitor

The SmartShunt IP65 is a battery monitor. It measures battery voltage and current. Based on these measurements, it calculates
the battery's state of charge and the time to go. It also keeps track of historical data, such as deepest discharge, average
discharge and the number of charge and discharge cycles.
A connection with the VictronConnect app
monitored battery parameters or to change settings. To connect via USB, an optional
If the battery monitor is connected to a GX device, such as the
locally with the GX device or remotely via the
The auxiliary input can be used to monitor the voltage of a second battery or the midpoint of a battery bank. The auxiliary input
can also be used for battery temperature monitoring, together with the optional
When connected to other Victron products via
as battery voltage and current via Bluetooth for use by Victron solar chargers and select AC chargers.

2.2. Why should I monitor my battery?

Batteries are used in a wide variety of applications, mostly to store energy for later use. But how much energy is stored in the
battery? No one can tell by just looking at it. The service life of batteries depends on many factors. Battery life may be shortened
by under-charging, over-charging, excessively deep discharges, excessive charge or discharge currents, and by high ambient
temperature. Monitoring the battery with a battery monitor will give important feedback to the user so that remedial measures can
be taken when necessary. Doing this will extend battery life and the battery monitor will quickly pay for itself.

2.3. Sizing

The SmartShunt IP65 is available in 3 sizes being: 500A, 1000A and 2000A.
SmartShunt IP65 500A, SmartShunt IP65 1000A and SmartShunt IP65 2000A.

2.4. The VictronConnect app

The VictronConnect app is essential to set up and monitor the battery monitor.
The VictronConnect app can connect to the battery monitor via:
• Bluetooth.
• USB, using the optional VE.Direct to USB
• Remotely via a GX device and the VRM portal.
The VictronConnect app is available for the following platforms:
• Android.
• Apple iOS (Note that USB is not supported, it is only possible to connect via Bluetooth).
• macOs.
• Windows (Note that Bluetooth is not supported, it is only possible to connect via USB).
The VictronConnect app can be downloaded from app stores or from the
code.
Page 2
Manual - SmartShunt IP65
is possible via Bluetooth or USB. The VictronConnect app can be used to read out all
Cerbo GX or the
VRM portal.
VE.Smart networking, the battery monitor can provide real-time battery data such
interface.
VictronConnect product page
VE.Direct to USB interface
ColorControl GX, the battery can be monitored
Temperature sensor for BMV.
or scan the below QR
is needed.
Introduction