Configuring The Quattro-Ii; Ve.bus Quick Configure Setup; Ve.bus System Configurator; Veconfigure - Victron energy Quattro-II 2x120V Manual

Quattro-II 2x120V
BoostFactor
Change this setting only after consulting with Victron Energy or with an engineer trained by Victron Energy!
Programmable relay
The relay can be programmed for all kinds of other applications, for example as a starter relay for a generator.
Auxiliary AC output (AC-out-2)
Intended for non-critical loads and directly connected to the AC input. With current measurement circuit to enable PowerAssist.

5.3. Configuring the Quattro-II

The following hardware is required:
• A MK3-USB (VE.Bus to USB) interface.
• RJ45 UTP cable

5.3.1. VE.Bus Quick Configure Setup

VE.Bus Quick Configure Setup is a software program with which systems with a maximum of three Multis (parallel or three
phase operation) can be configured in a simple manner.
The software can be downloaded free of charge at www.victronenergy.com.

5.3.2. VE.Bus System Configurator

For configuring advanced applications and/or systems with four or more Multis, VE.Bus System Configurator software must be
used.
The software can be downloaded free of charge at www.victronenergy.com .

5.3.3. VEConfigure

All settings can be changed with a PC and free of charge software VEConfigure, downloadable from our website
www.victronenergy.com. See this manual for more information - VEConfigure

5.3.4. VictronConnect

The MultiPlus is configured using VictronConnect. More general information about the VictonConnect app - how to install it; how
to pair it with your device; and how to update firmware, for example - can be found by referring to the overall VictronConnect
manual.
Page 19 Configuration