Table of Contents
Advertisement
open the door in front of the shuttle by means of the small
recesS on the left side.
GriP the bobbin case with the thumb and index finger so
that the latch is depresse d and pull the bobbin case out.
The bobbin will remain in the case as long as the latch is
dePress& J When you release the latch, the bobbin will be
released .
Turn the empty bobbin until the small round mark
on one
side 15 outward .
Slide the bobbin onto the bobbin winding spindle located
n the right side of the
machine . Raise the presser foot
and pull the thread
from the thread guide on the needle
clamp through the
thread guide on the right of the
machine to the bobbin.
Wind the thread around the bobbin a couple
of times,
eginnmg from undernea th,
you are using a metal
nreSser foot, allow the thread to go through the eye of the
eedle and under the presser foot. Never run the thread
direct from the eye of the needle to the bobbin because
iou will run the risk of bending the needle. Hold the thread
nd and lightly depress the foot control.
As soon as wind
ing starts you can
release the thread end.
When the bobbin winding is finished, place the bobbin in
its case with the marking upward.
The thread should run
as shown in the figure.
Slide the thread into the slot on the edge of the bobbin
case. Pull the thread in under the tension spring. Check
that the bobbin rotates in the direction of the arrow (clock
wise) when the thread is pulled.
The thread must be pulled in the direction of the spring,
otherwise the spring will be overload ed.
Slide the thread behind the projection of the bobbin case
and to the right. Put the bobbin case into place. Press the
bobbin case until it clicks to ensure that it fits properly. The
thread cutter is located to the left of the bobbin case. Hold
the thread end and draw the thread from undernea th and
up toward the thread cutter. By doing so the thread will be
cut off and kept in place. Shut the door.
Raise the presser foot. Check that the needle is at its
highest position. Place the spool of thread on the left spool
pin and thread the machine for sewing.
Slide the thread into thread guide 2 on the upper arm and
draw
it
upward. Then draw the thread to the front between
the tension discs 3 and down around thread guide 4.
Continue threadin g by drawing the thread from the right
into the slot on thread take-up lever 5 and draw it down to
the needle, ensuring that it goes through thread guide 6.
Thread the needle from the front. Due to the white color of
the presser foot ankle the needle-e ye is clearly seen and
the threading of the needle 7, is easier. Pull the thread
under the presser foot about 15 cm (6") toward the rear.
Hide quick links:
Advertisement
Table of Contents
