Table of Contents
Advertisement
2.10 Remove flash heater
1
► Make sure that the hoses of the flash heater are installed correctly, see section "2.14 Hose
positions" on page 21.
If the hoses are swapped, the Sprso will steam instead of giving hot water when the flash heater
is switched on.
Step 1
• remove the 2 screws
• remove the 2 locking clips to disconnect the
hoses (consider to exchange the O-rings)
► The lower connection is the cold water input.
► The upper connection is the hot water output.
Step 2
• disconnect the wiring
• remove the flash heater
► Consider to exchange the O-rings.
1. high temperature safety switches (non
reset-able)
2. temperature sensor
2
17
Advertisement
Table of Contents
