Unpairing The Receiver With The Transmitter; Technical Specifications - DELTA DORE Tybox 5150 Installation And User Manual

8. Unpairing the receiver with the transmitter

If there's a fault, you may need to unpair a product and/or re-associate a new one.
Wireless resetting of the transmitter
1
mode mode
>3s
❶On the Tybox, briefly press a
button to wake up the display,
then press and hold both the
mode and + buttons for 3 seconds.
Removing associations from the receiver
The deletion of wireless associations with the receiver is carried out by
holding down the button.
The LED will cycle through the various states.
: The LED flashes red. The receiver is in pending association mode.
: The red LED flashes rapidly. The receiver is waiting to delete the association with a door/window magnetic
contact (check on the device you want to unpair).
: After 20 seconds. The red LED turns off. All pairings with the receiver are now removed.

9. Technical specifications

TYBOX 5101 transmitter
• Power supply using 2 batteries:
2x1.5V Alkaline - Type LR03-AAA
• Class III insulation
• X3D transmission frequency: 868.7 MHz to 869.2 MHz
• Maximum wireless power < 10 mW
• Category II receiver
• Wireless range of 300 metres outside, varies depending on
the associated equipment (the range can vary depending
on the installation conditions and the electromagnetic
environment).
• Wall-mounted or on base
• Dimensions: 80 x 84 x 21 mm
• Protection Class: IP 20
• Installation in an environment with normal pollution levels
• Storage temperature: -10°C /+70°C
• Operating temperature from -10°C/+40°C
2
>3s
❷ The screen displays rF--
depending on the number of
associated receivers
(e.g.: rF01 for a single receiver, rF02
for 2 receivers etc...).
Press - for 3 seconds to confirm
the reset.
The screen displays rF00.
A
3s
3
mode
❸ Briefly press the mode and +
buttons at the same time.
The screen displays dF 0
(transmitter not yet associated).
If the receiver is supplied with power
and is within the wireless range of the
transmitter at the time of the reset, the
transmitter will also be deleted on the
receiver.
> 20s
B
10s
RF 6200 receiver
• Power supply 230 V-+/- 10% ~, 50 Hz
• Consumption: 1,8 W max.
• Class II insulation
• Contact output 5 A max., 230V ~
• Type 1.C automated action
• Dimensions: 54 x 140 x 25 mm
• X3D transmission frequency: 868,7 MHz à 869,2 MHz
• Maximum wireless power < 10 mW
• Category II receiver
• Wireless remote control device
• Wireless range of 300 metres outside, varies depending on
the associated equipment (the range can vary depending
on the installation conditions and the electromagnetic
environment).
• Protection rating: IP 43
- vertical positioning of the product.
• Storage temperature: -10°C /+70°C
• Operating temperature: -10°C / +40°C
• Ball test temperature: 75°C (Housing),
• Rated impulse voltage: 2,500V
C
20s
7