Pairing With The Tydom App; Pairing A Door/Window Magnetic Contac; Associating A Repeater - DELTA DORE Tybox 5150 Installation And User Manual

5. Pairing with the Tydom app

Launch the Tydom application from your smartphone or tablet, then:
Settings -> My devices -> Add a device -> Heating -> Hydraulics -> TYBOX 5150 (RF6200)... and follow the
instructions.
For more information, refer to the "Operation with the Tydom application" section.

6. Pairing a door/window magnetic contac

Pairing a motion sensor means you can switch the heating to Frost Protection or the air conditioning to Off if a
window is opened (after 10 seconds).
2
1
> 3s >3s
> 3s
mode
1
... ... ...
1
... ... ...
... ... ...
❶ Press the receiver button for 3
seconds until the red LED flashes.

7. Associating a repeater

If the radio range is too weak and the transmitter cannot be moved closer to the receiver, you can add an X3D
radio repeater to your installation (example: ERX 2000).
1
>3s
... ... ...
❶ Press the ERX 2000
receiver button for 3
seconds until the red
LED flashes. Release.
To verify the number of associated repeaters:
1
mode mode
>3s
❶ On the Tybox, briefly press a
button to wake up the display,
then press and hold both the
mode and + buttons for 3 seconds.
The screen displays rFxx
(depending on the number of
associated products). Release.
mode
mode
2
2
>3s
❷ Briefly press the detector
button.
2
mode mode
>3s
❷ On the Tybox, briefly
press a button to wake
up the display, then
press and hold both the
mode and + buttons for
3 seconds.
The screen displays
rFxx (depending on the
number of associated
products). Release.
2
mode
❷ Press and hold mode for 3
seconds. The screen displays
rP depending on the number of
associated repeaters.
(eg: rP01 for 1 repeater).
3
mode
2
>3s
3
❸ Press briefly on +. The
screen flashes until rF is
displayed depending on
the number of associated
receivers and repeaters
(❹)
(e.g. rF02 for 1 receiver and
1 repeater).
Check that the repeater's
LED is no longer flashing.
>3s
4
OFF
OFF
OFF
3
3
3
❸ Make sure that the receiver LED
has stopped flashing.
4 5
OFF
mode
❺ To exit the mode,
briefly tap the mode and +
buttons simultaneously.
3
mode
>3s
❸ To exit:
- return to the rFxx menu, press
mode for 3 seconds,
- return to the initial display, briefly
press the mode and + buttons
simultaneously.
5
mode
6