Installing The Receiver; Location; Mounting / Connection; Pairing The Receiver To The Transmitter - DELTA DORE Tybox 5150 Installation And User Manual

2. Installing the receiver

2.1 Location

The receiver must be installed at a minimum
distance of 20 cm from any metal surface (e.g.
the heat pump), and about 1.50 m from the
ground to ensure there's a good radio link with
the transmitter.

2.2 Mounting / Connection

❶ First of all, switch off the power to your
installation.
❷ The receiver can be secured by suitably sized
screws or by adhesive (supplied).
❸ Connect the receiver
❹ Once the receiver is connected, turn on the
power to your installation.

3. Pairing the receiver to the transmitter

1
>3s
... ... ...
❶ To associate it, press the receiver
button for 3 seconds, until the red
LED flashes. Release.
mode
mode
2
>3s
❷ On the Tybox, briefly press a
button to wake up the display, then
press and hold both the mode and +
buttons for 3 seconds.
The screen will display rF00. Release.
❸ Press briefly on +. The screen
flashes until rF is displayed
depending on the number of
associated receivers (eg. rF01 for a
single receiver, rF02 for 2 receivers
etc.).
OFF
2 connection options depending on the characteristics of the generator:
: 1 thermostat input and 1 change-over control input
: 1 "Hot thermostat" input and 1 "Cold thermostat" input
5A - 230V~
1 2 3 4 5 6 7 8
Th
Change-over
ON
3
❹ Check that the LED of the
receiver(s) is no longer flashing.
To exit the mode, briefly press the
mode and + buttons simultaneously.
>20 cm
1,50 m
5A - 230V~
L N
1 2 3 4 5
230V~
50 Hz
Th Cool Th Heat
OFF
mode
4
L N
6 7 8
230V~
50 Hz
4