Configuring Your Device; Menu Cf00 Backlit Display; Menu Cf01 Correcting The Temperature Measured; Menu Cf02 Locking The Buttons - DELTA DORE Tybox 5150 Installation And User Manual

4. Configuring your device

1
❶ Press any button to activate the
screen.
❷ Press mode for 10 seconds until
CF00 is displayed.

Menu CF00 Backlit display

Default setting: Back-lighting activated
Activated (automatic switch-off)

Menu CF01 Correcting the temperature measured

This menu is used to correct any difference you have noticed between the displayed temperature and the
measured temperature.
Example: If the temperature displayed by the device is 19°C and the measured temperature is 20°C, input +1°C then
confirm using OK.
Adjusts from -5°C to 5°C,
in increments of 0.1°C.

Menu CF02 Locking the buttons

This menu allows you to prohibit any changes (settings, set point, mode).
Default setting: Authorised changes

Menu CF03 Not used

Please leave the setting at 00.
> 5s
2
❸ Press + or - to adjust the setting,
and on mode to move to the next
menu.
Deactivated
No locking
Locking active
mode
3
mode
In order to change this setting, the unit
must have been running for at least 2 hours
beforehand.
Default setting: 0°C
If locked, the screen will display "----".
To temporarily unlock, simultaneously press
and hold the + and - buttons for 5 seconds.
mode
> 5s
4
❹ Press mode for 5 seconds to exit
the configuration menu or, after a
period of 2 seconds without activity,
the Tybox validates the change of
parameter and returns to standby.
5