Advertisement
PartsArena
These should be assembled to the stove as in
plate in place (See
figure
Figure 2.
5. The down draught diverter is secured in place using the front bolt and nut that secure the cast collar to the outside of the cast
body. Unscrew and remove the nut and washer from inside the top of the casting body. Position the down draught diverter as in
figure
3. It MUST be sealed against the top of the stove casting. It is important that it sits on top and between the raised cast
areas on the rear of the stove body (See
Figure 3
Page 7
6. The Thermal Switch should be fitted to the inside of the Diverter Box as in
Never modify the fixing bracket and always ensure that the switch is fitted correctly. NEVER USE THE STOVE IF THE
THERMAL SAFETY SWITCH HAS BEEN REMOVED OR IF IT IS DAMAGED IN ANY WAY.
http://www.partsarena.com/baxi/[15/07/2008 11:36:43]
figure
2).
figure
3). Secure in place using the nut and washer removed previously.
2. The flue spigot is screwed to the cast collar and clamps the flue restrictor
figure 4.
Secure using the nut and bolt supplied.
Advertisement
