Installation - Ignition Gawan 200 User Manual

4

Installation

Unpack and check carefully there is no transportation damage before using the unit.
Keep the equipment packaging. To fully protect the product against vibration, dust
and moisture during transportation or storage use the original packaging or your
own packaging material suitable for transport or storage, respectively.
Lift the device only at the base. When lifted at the rotatable mounting, the device
may be damaged.
You can install the device standing or hanging. When in use, the device must be
mounted at a solid surface or clamped to an approved truss.
Work from a stable platform whenever you install or move the device or when you
perform any kind of maintenance. Block access under the work area.
WARNING!
Risk of injury caused by falling objects
Make sure that the installation complies with the standards and rules
that apply in your country. Always secure the device with a secondary
safety attachment, such as a safety cable or a safety chain.
The load capacity of trusses or other fixtures must be sufficient for the
intended number of devices. Not that the movement of the head places
additional loads on the load-bearing parts.
CAUTION!
Risk of injury due to movements of the device
The head of the device can move quickly (pan, tilt) and can produce
very bright light. This is also valid immediately after you turn on the
device, when the device operates in automatic mode or under remote
control and when you turn off a DMX controller that is connected to the
device. Persons staying near the device could be injured or frightened.
Before you turn on the device and during the operation, always ensure
that nobody stays close to the device. If work has to be performed in the
area of movement or in the near vicinity of the device, it must remain
turned off.
NOTICE!
Risk of overheating
The distance between light source and the illuminated surface must be
more than 0.5 m.
Provide sufficient ventilation.
The ambient temperature must always be below 40 °C.
NOTICE!
Possible damage caused by movements of the device
Always ensure that enough space is free around the device for the
movements of the head (pan, tilt).
Installation
Gawan 200
9
Moving Head