Installation - Beko 71261 AL Owner's Manual

3

Installation

Please contact the nearest Authorized
Service for the installation of the product.
Check if the electrical installation and water
drain is proper before calling the authorized
service to have the product ready for
operation. If not, call an electrician and
plumber to arrange the utilities as
necessary.
Installation shall be performed as per
the local standards and you shall follow
the National Electrical NFPA 70/ANSI
C1- -1003 standard if no local standard
is available.
It is customer's responsibility to prepare
the location the product shall be placed
on and also have power and waste
water installation prepared.
Cable connection between indoor and
outdoor unit shall be rendered safe and
secure and it shall follow a suitable
route that it shall not be pulled away
from cable terminal blocks by any load.
Improper connection may cause
generation of heat or fire.
Install the panel and cover of the control
box securely.
Do not place the product in the vicinity
of areas with explosion or fire risk.
Failure to do so may cause explosions
or fire.
Do not mix any gas or air into the
system other than the refrigerant used
in the system. If air enters the refrigerant
system, it can cause very high
pressures, which can result in personal
injuries or equipment malfunction.
Use packed materials such as screws,
nails or batteries carefully after
installation or repair. Otherwise, these
may cause serious injuries.
Attach the condensation drain hose so
that it can easily drain water. If this shall
be neglected, it may cause the product
to malfunction.
When installing or repairing the air
conditioner, be sure to check for
refrigerant leakage.
Do not contact if leakage is present. It
may cause product malfunction.
p
g g
11
Installation and power connections
shall be made by an Authorized
service. Manufacturer shall not be held
responsible for damages caused by
operations performed by unauthorized
persons.
Check for any damage on the product
before installing it. Do not have the
product installed if it is damaged.
Damaged products cause a risk for your
safety.
Anyone working on the cooling circuit
shall have a valid certificate issued by
the competent authority, which certifies
their competence to work on the
refrigerant acknowledged by the
industry.
Service work shall only be carried out as
recommended by the manufacturer.
Maintenance and repair, which requires
the support of other workers with
different expertise, shall be carried out
under the supervision of a person
qualified in the use of flammable
refrigerants.
The device shall be stored in a
well-ventilated place suitable for the size
specified for operation.
The devices shall be stored in such a
way that there are no continuous open
flames
(e.g. a working gas appliance) and
ignition sources (e.g. a working electric
heater).
The device shall be stored in such a
way that it cannot be mechanically
damaged.