Functions And Settings - Klarstein STUDIO 5 ARC Manual

EN
24

FUNCTIONS AND SETTINGS

Main switch (A)
Open the cover on the bottom of the unit and press button A down to the ON position.
On / Off button (B)
Press the on / off button to start the flame effect. The following will appear on the
display:
• The heating symbol will be displayed and the appliance will
start to heat if the room temperature is below the standard
setting (10 ° C). If the temperature is higher than 10 ° C, the
icon will not be displayed and the unit will not heat up.
• The clock symbol will flash to indicate that no timer has
yet been set. Follow the steps described in the „Operating
Modes" section under „Timer Mode" to set the timer.
If [H10] is displayed, it means that the heating for the high heating power is set to
10 °C. If [L10] is displayed, it means that the heating is set to 10 °C for the low heating
power. For example, if [26C] is displayed, it means that the room temperature is 26 °C.
Key lock (C)
Press and hold the OK button for more than 6 seconds to lock or
unlock the keys. As soon as the keys are locked, [LOC] flashes
on the display for 6 seconds and then disappears. Press any key
and [LOC] will flash again. Press the OK button for 6 seconds to
unlock the keys.
Note: The On / Off button (B) is never locked.