Operation And Settings - Klarstein VERBIER 10034396 Manual

Timer starting and timer shutdown
While setting the timer, the setting time is displayed, and the timer is used in combination
with serial number setting.
E.g. Means the starting time of setting 5 is 23:40.
E.g. means the shutdown time of setting 5 is 6:10.
Flame brightness
It displays the current brightness of the flame, which ranges from one to five positions.

OPERATION AND SETTINGS

Boot steps
1 Connect the power.
2 Turn on the power switch.
3 Press the control switch or "ON/OFF" key of the remote controller to start up.
4 Press once the 1000 W button for the low heat settings; press twice to switch off the
heat setting.
5 Press once the 2000 W button for the high heat settings; press twice to switch off
the heat setting.
6 Press the DIMMER button for operate the dimmer mode.
Adaptive start control function
Press "IC" button on the remote controller to start or close the adaptive start control
function. When turned on this function, the fireplace can automatically change the
heating mode, and this is depend on the setting temperature and the room temperature.
When the timer is on, it is possible to start the heating ahead of the schedule.
Note: Adaptive start control function is only working when the week timer systerm is
power on.
EN
23