Operation And Settings - Klarstein Basel 10030743 Manual

Timer starting and timer shutdown
While setting the timer, the setting time is displayed, and the timer is used in combination
with serial number setting.
E.g. Means the starting time of setting 5 is 23:40.
E.g. means the shutdown time of setting 5 is 6:10.
Flame brightness
It displays the current brightness of the flame, which ranges from one to five positions.

OPERATION AND SETTINGS

Boot steps
1 Connect the power.
2 Turn on the power switch.
3 Press the control switch or „ON/OFF" key of the remote controller to start up
4 Press the 1000W/2000W button once for the low heat setting 1000W; press
twice for the high heat setting 2000W; press three to switch off the heat setting.
5 Press the DIMMER button to operate the dimmer mode, repeat pressing will raise
and lower the brightness.
6 Press the BACK LIGHT button to adjust the colors of LED decoration, 7 colors
available.
Adaptive start control function
Press „IC" button on the remote controller to start or close the adaptive start control
function. When turned on this function, the fireplace can automatically change the
heating mode, and this is depend on the setting temperature and the room temperature.
When the timer is on, it is possible to start the heating ahead of the schedule.
Note: Adaptive start control function is only working when the week timer systerm is
power on.
EN
25