Topgreener TDOS5 - Occupancy/Vacancy 2-In-1 Sensor Switch Installation Manual

DESCRIPTION

The TDOS5 uses advanced passive infrared sensor to detect heat emitted motion. The sensor switch can turn on a load and keep it on as long as it detects motion. The sensor will automatically shut off the load at the end of the selected time delay. The countdown of the selected time delay starts after the last motion detected. The sensor is customizable with dials that can adjust Time Delay, detection Range, ambient Light Level, and a switch to change between Occupancy/ Vacancy modes.

COVERAGE

As illustrated in Figure 1, The TDOS5 has a 180° detection range with a maximum distance of 20' detection in front of the sensor and 10' on the sides. For maximum results, the sensor must be properly installed between the height of 4' to 5' and away from obstructions such as walls, furniture and transparent barriers like Low-E glass.

Turn the POWER OFF at the circuit breaker before installing the sensor
Read and understand these instructions before installing. This device is intended for installation in accordance with the National Electric Code and local regulations. It is recommended that a qualified electrician performs this installation. Make sure to turn off the circuit breaker or fuse(s) and make sure power is off before wiring the device.
Use copper wires only.

WIRING DIRECTIONS

1. Test and Label all wires before installing the sensor. You must have a HOT, NEUTRAL, and LOAD wires in the switch box. DO NOT connect the WHITE (Neutral) wire and the RED (Load) wire on the sensor together. Otherwise, the load will keep flashing.
2. Connect RED wire from sensor to the LOAD wire.
3. Connect BLACK wire from sensor to the HOT wire.
4. Connect WHITE wire from sensor to the NEUTRAL wire. NEUTRAL WIRE IS REQUIRED.
5. Connect GREEN wire from sensor to the GROUND wire.

ADJUSTMENT

The control panel cover is also the push button on the switch. Remove the push-button cover plate by prying from the bottom of the push-button and pulling outward.

Time dial
This dial adjusts the time delay. Default position: 15 Seconds (Test mode) Adjustable:
from 15 Seconds to 30 Minutes (clockwise)

Range dial
This dial adjusts the detection range. Default position: Center at 65%Adjustable: 30%
(Position 1) to 100% (Position 4).
Note: Use the greater setting for larger coverage area.

Light dial
The sensor may be adjusted to operate at the desired level of ambient light.

• To do so, turn the dial counter clockwise for sensor to detect motion and operate during low light or no light. Turn the dial clockwise for sensor to operate when there's more light in the area or even during daylight.

Off/ Occupancy/ Vacancy Mode Switch

OPERATION

Off/ Occupancy/ Vacancy Mode Switch
The OFF position: Switch is turned off and will not detect motion. The push button will not function.

OCCupancy position: The load will automatically turn on when motion is detected and automatically turn off when the selected time delay has expired. The push button may be used to manually turn ON/OFF the load and time delay will also take effect.

VACancy position: The load will turn on ONLY when the push button is used and automatically turn off when the selected time delay has expired. The push button may be used to manually turn ON/OFF the load and time delay will also take effect. If the time delay has expired and the load turns off, the load will turn on again automatically if motion is detected within 30 seconds.

SPECIFICATIONS

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Topgreener TDOS5 - Occupancy/Vacancy 2-In-1 Sensor Switch Installation Manual