NordicTrack NTL18423.2 User Manual page 13

10. Remove the 5/16" Nut (34), the two 3/8" Thrust
Washers (29), and the 5/16" x 1 3/4" Bolt (22)
from the bracket on the Upright Base (94).
Note: If one of the 5/16" Bushings (108)
comes out, reinsert it.
Next, orient the Storage Latch (56) as shown.
Attach the lower end of the Storage Latch (56)
to the bracket on the Upright Base (94) with
the 5/16" x 1 3/4" Bolt (22), the two 3/8" Thrust
Washers (29), and the 5/16" Nut (34).
Then, raise the Storage Latch (65) to a vertical
position, and remove the tie (K).
11. Remove the 5/16" Nut (34) and the 5/16" x
2 1/4" Bolt (23) from the bracket on the Latch
Crossbar (53).
Next, align the upper end of the Storage Latch
(56) with the bracket on the Latch Crossbar (53),
and insert the 5/16" x 2 1/4" Bolt (23) through the
bracket and the Storage Latch. This will push a
spacer (L) out of the Storage Latch; discard
the spacer. Note: If one of the 5/16" Bushings
(108) comes out, reinsert it.
Next, tighten the 5/16" Nut (34) onto the
5/16" x 2 1/4" Bolt (23). Do not overtighten the
Nut; the Storage Latch (56) must be able to
pivot.
Then, lower the Frame (57) (see HOW TO
LOWER THE TREADMILL FOR USE on
page 28).
10
K
34
11
34 L
108
57
13
56
29
108
94 108
29
22
53
23
56