RIOTEC DC9258J Programming Quick Manual

Programming Quick Guide
-DC9258J/DC9258K: Docking Scanner
-DC9268J/ DC9268K: Wearable Scanner
Docking Scanner:
Gently tap the trigger area at the middle of scanner, to enable the
scanner(for reading barcode)
Wearable Scanner:
Press the ring trigger to enable the scanner.
Up Side
Trigger
Area
The touch sensor area is around middle of the scanner as drawing shown.
Reset Configuration to Default :
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan from A for USB HID or B for RS232 or
USB Serial. This will reset the scanner to its factory defaults.
A B
*
Note : Please install PL-2303 driver for USB serial
Keyboard Language
Scan the appropriate country code as below to program the
keyboard layout for your country or language. As a general
rule, the following characters are supported, but need special
care for countries other than the United
@ | $ # { } [ ] = / ' \ < > ~
United states
of America
French
Norwegian
Lower Side
Spanish
Swedish
Japan
Finnish
States:
German
French Mac
Belgian
Italian
United
Kingdom
Korean
Portuguese
1
1D Symbologies -1
UPC-A/E
ENABLE
JAN/EAN
ENABLE
Code 128
ENABLE
Code 39
ENABLE
Tri-optic
ENABLE
CODE 93
ENABLE
CODE 11
ENABLE
DISABLE
DISABLE
DISABLE
DISABLE
DISABLE
DISABLE
DISABLE