RIOTEC DC9257J Programming Quick Manual

Programming Quick Guide
-DC9257J: Docking Scanner
-DC9267J: Wearable Scanner

Docking Scanner:

Gently tap the trigger area at the middle of scanner, to enable the
scanner(for reading barcode)

Wearable Scanner:

Press the ring trigger to enable the scanner.

Installation

They are Plug &Play USB (HID) devices. When plugged into your Android
OTG devices, it can be recognized as barcode scanner and begin to scan
the barcode. Before using scanner, make sure the smartphone or tablet
is fully charged. Open your APP, they can work as a keyboard input.

Reset Configuration to Default

If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan the following 5 barcodes. This will reset the
scanner to its factory defaults settings.
1
2
3

Barcode Configuration Method:

(Flow chart for setup procedure :)
Start
Configuration

Keyboard Country

Scan the appropriate country code below to program the keyboard for
your country or language. As a general rule, the following characters
are not supported by the scanner for countries other than the United
States: @ | $ # { } [ ] = / ' \ < > ~
USA
(Original setting)
Denmark
4
France
5
Italy
Level Trigger
ENABLE
ENABLE
End
Configuration
ENABLE
ENABLE
ENABLE
Japan
ENABLE
ENABLE
Finland
ENABLE
Turkey_F
ENABLE
Norway
1

READING MODE

Pulse Trigger
1D Symbologies On/Off – 1
CODE 39 DISABLE
CODE 39 Transmit
Start/Stop Character DISABLE
CODE 39
FULL ASCII DISABLE
CODE 128 DISABLE
GS1-128
UCC/EAN-128 DISABLE
EAN-8 DISABLE
EAN-13 DISABLE
ISSN DISABLE
ISBN DISABLE