RIOTEC DC9267 Programming Quick Manual

P r o g r a m m i n g Q u i c k G u i d e
-DC9257: Docking Scanner
-DC9267: Wearable Scanner
Docking Scanner:
Gently touch the trigger area at the middle of scanner, to
enable the scanner(for reading barcode)
Wearable Scanner
:
Press the ring trigger to enable the scanner.
Installation
They are Plug &Play USB (HID) devices. When plugged into
your Android OTG devices, it can be recognized as barcode
scanner and begin to scan the barcode. Before using scanner,
make sure the smartphone or tablet is fully charged. Open
your APP, they can work as a keyboard input.
Reset Configuration to Default
If you are unsure of the scanner configuration or have
scanned the incorrect codes, please scan the following 3
barcodes. This will reset the scanner to its factory defaults
settings.
** Code Programming ON
(Pro CMD : 0006010)
Load Factory Default
(Pro CMD : 0001160)
** Code Programming OFF
(Pro CMD : 0006000)
Keyboard Country
Scan the appropriate country code below to program the keyboard for
your country or language. As a general rule, the following characters
are not supported by the scanner for countries other than the United
States: @ | $ # { } [ ] = / ' \ < > ~
USA
(Original setting)
Norway
Germany
Sweden
Denmark
Switzerland
Barcode Configuration Method: (Flow chart for setup procedure :)
Italian
Start Configuration
France
** Code Programming ON
(Pro CMD : 0006010)
Vietnam
Trigger Mode
Pro CMD : 0302000
Spain
1D Symbologies On/Off – 1
CODE 39
ENABLE
Portugal
Pro CMD : 0408020
CODE 93
ENABLE
Hungary
Pro CMD : 0410020
End Configuration
** Code Programming OFF
(Pro CMD : 0006000)
READING
Auto-Sensing
MODE
Pro CMD : 0302010
CODE 39 CODE 39
DISABLE
Pro CMD : 0408010
CODE 93 CODE 93
DISABLE
Pro CMD : 0410010