Soaking Laundry; Adding Laundry; Cancelling The Programme; Resuming The Programme When The Programme Status Is Rinse Hold - Siemens WM14VKH0GC User Manual

The drum rotates and load detec-
a
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
The display shows the programme
a
duration or the programme end
time.
After the programme has ended,
a
the display shows: -0-.
13.7 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start / Re-
load.
To resume the programme, after
3.
the desired soaking time, press
Start / Reload.
13.8 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press Start / Reload.
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 21
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press Start / Reload.
5.
13.9 Cancelling the pro-
gramme
Press Start / Reload.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 25
Remove the laundry.
3.
→ "Unloading the laundry",
Page 31
13.10 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
Rinse Stop is activated.
¡
→ "Buttons", Page 23
The last rinse cycle of the set pro-
¡
gramme has ended and the laun-
dry is in the rinsing water.
Set the Spin programme or a pro-
1.
gramme for draining the water.
→ "Programmes", Page 25
Press Start / Reload.
2.
13.11 Unloading the laundry
Open the door.
1.
Remove the laundry from the
2.
drum.
13.12 Switching off the appli-
ance
Press .
1.
Turn off the tap.
2.
operation en
31