Input Of Rim Dimensions (Alu-Se Or Laser Version); Detecting And Correcting Umbalance - Fasep VIDEOTRONIC V653.G2 User Manual

Fasep 2000 srl
Videotronic V653.G2: User's Manual
7.3

Input of Rim Dimensions (ALU-SE or LASER version)

!
CAUTION:
Fig. 61
Fig. 62
7.4

Detecting and correcting umbalance

7.4.1 After setting wheel dimensions, press <START> or close the safety cover to spin the wheel and start the measurement
run.
!
CAUTION:
7.4.2 At the end of the spin the wheel will brake automatically and the display will show the weight position and weight
requirement to correct the wheel's umbalance.
7.4.3 Apply the weights (fig.63, fig.64). If umbalance shown is 0, press <FINE> to show residual umbalance.
Fig. 63
Laser installed on wheel balancer is of class 2, so special protection are not required. It is however
recommended to avoid the continuos view of the direct beam.
MAIN MENU > INPUT
Press ALU MODE untill the required position of weight is on the video (fig.61).
Insert the distance (IN1).
Insert the distance (IN2).
Press ALU MODE untill the required position of weight is on the video (fig.61).
Insert the distance (IN1).
Insert the distance (IN2).
wheel start automatically when safety cover is closed.
Fig. 64
4-4
Rev. 1.3
02 april 2010