How To Apply The Weight Using Alu-Se Applicator; How To Apply The Weight Using Laser; How To Use Split Program - Fasep VIDEOTRONIC V653.G2 User Manual

Fasep 2000 srl
Videotronic V653.G2: User's Manual
7.5

How to apply the weight using ALU-SE applicator

Fig. 65
7.6

How to apply the weight using LASER

Fig. 68
7.7

How to use SPLIT Program

After the measurement spin
Press <SPLIT> to select the program.
Turn the wheel until first spoke (green position) is at 12 0' clock.
Press <SET/OK> to confirm.
Turn the wheel until second spoke (red position) is at 12 o' clock
Press <SET/OK> to confirm the red position.
Balance the wheel applying weight on green and red positions.
Place the weight as in the picture 66.
Turn the wheel until reach the application
position of the weight (fig. 65).
Move the rod until reach the application
position of the weight (fig. 66).
Apply the weight (fig. 67).
Repeat the procedure for the other side.
.
Turn the wheel until the position weight
indicators of one side are both green (fig. 68).
The laser come out to show the point of
application of the weight (fig. 69).
Apply the weight on the laser dot.
Repeat the procedure for the other side.
4-5
Fig. 66
Fig. 67
Fig. 69
Rev. 1.3
02 april 2010