Close-To-Ceiling Mounting - HAMPTON BAY 1002 498 557 Use And Care Manual

Assembly — Close-to-Ceiling Mounting
1
Preparing the canopy
□
Remove the canopy ring (B) from the canopy (C).
□
Remove the mounting bracket (A) from the canopy (C)
by loosening the four canopy mounting screws with
lock washers (BB) on the top of the canopy (C).
Remove the two non-slotted canopy mounting
screws with lock washers (BB) and loosen the slotted
canopy mounting screws with lock washers (BB).
□
Remove the canopy bottom cover (D) from the
canopy (C).
BB
A
3
Assembling the fan
WARNING: Failure to completely tighten the three collar
mounting screws (HH) could result in the fan becoming loose
and possibly falling.
□
Make sure the slot openings of the canopy ring (B)
are on top, and then proceed to place the canopy ring
(B) and canopy (C) over the collar at the top of the fan
motor assembly (G).
□
Align the mounting holes in the bottom of the canopy
(C) with the holes in the top of the fan motor
assembly (G). Fasten using the three collar mounting
screws with lock washers (HH) previously removed.
□
Tighten the collar mounting screws (HH) securely.
2
□
□
BB
C
B
D
10
Preparing the motor
Remove the cotter pin (FF), clevis pin (EE) and the
two collar setscrews (GG) from the motor collar.
Remove three of the six collar mounting screws with
lock washers (HH) (every other one) from the collar
on top of the fan motor assembly (G).
EE
HH
FF
GG
G
GG
HH
C
B
G