Table of Contents
Advertisement
SL BAR 660 RGBW LED Luminaires
CAUTION: In the event the AC input cable of this luminaire is damaged, it must be replaced, by the user, with an
approved cable through an Authorized Showline Dealer or Service Center.
3. Connecting to the DMX512 Network
Basic DMX512 installation consists of connecting multiple SL BAR 660 RGBW LED Luminaires together (up to 32
luminaires) in "daisy-chain" fashion. A cable runs from the control console (or DMX512 control source) to the DMX
connector on the first SL BAR 660 RGBW LED Luminaire. Another cable runs from the other DMX connector on
the first unit to a DMX connector on the next SL BAR 660 RGBW LED Luminaire (or DMX512 device to be
controlled).
Bottom of Unit
DMX512 / RDM Input
Note: For more information on DMX512 networking and systems, refer to
page
1. For SL BAR 660 RGBW LED Luminaire DMX Mapping, refer to
DMX512
(from console or
control device)
Sh wline
Figure 5: SL BAR 660 RGBW LED Luminaire DMX512 Input / Output Connections
DMX512
(out from first
to second luminaire)
Note: Remaining pins on each connector are not used.
Figure 6: SL BAR 660 RGBW LED Luminaire - DMX512 Connections
SL BAR 660 RGBW
LED Luminaires
DMX512
(out to the next
luminaire or DMX512
controlled device)
DMX512 Connections
DMX512 Signal
XLR Pin
Common (Drain)
1
DMX512 -
2
DMX512 +
3
Installation & User's Manual
DMX512 / RDM Output
"Additional Resources for DMX512" on
"DMX CONTROL" on page
Connecting to the DMX512 Network
21.
9
Advertisement
Table of Contents
