Table of Contents
Advertisement
SL BAR 660 RGBW LED Luminaires
CLEANING AND CARE
WARNING! All cleaning should be performed with power completely removed from the luminaire. Never remove
protective covers when luminaire is powered. Wear appropriate protective eye wear and gloves when cleaning the
fixture. All service and maintenance, other than described herein, should be performed by a qualified technician or
Authorized Service Center.
1. Special Cleaning and Care Instructions
Being a solid-state fixture, and unlike most fixtures, the SL BAR 660 RGBW LED Luminaire requires very little
routine maintenance by the user. This section covers portions of the luminaire that can be removed for cleaning.
The SL BAR 660 RGBW LED Luminaire special care when it comes to cleaning front lens assembly. Additional care
needs to be taken with the plastic components because they are much easier to scratch or damage than glass.
The following is a list of cleaning materials required to care for your SL BAR 660 RGBW LED Luminaire:
• Lint free lens tissue
• Lint or powder free gloves
• Reagent grade isopropyl alcohol*
• A mild soap solution.
Note: *Reagent grade isopropyl alcohol is good to use on the SL BAR 660 RGBW LED Luminaire plastic optics
with anti-reflection coatings.
If the lens is still dirty after using isopropyl alcohol, for instance if fingerprints or oil is just redistributed and not
cleaned off the optic, then a mild soap and water solution can be used to gently wash the lens. Repeat the cleaning
with isopropyl alcohol to eliminate streaks and soap residue.
WARNING! Under no circumstances should ammonia-based cleaners, acetone, or other harsh solvents be used on or
near the SL BAR 660 RGBW LED Luminaire. These types of cleaners or solvents can permanently damage the
optics or housings of the fixture.
If you have any questions regarding the use or care of your SL BAR 660 RGBW LED Luminaire, please contact
Showline technical support or your local Authorized Dealer.
2. Front Lens Cleaning
To clean the front lens:
Step 1. Disconnect luminaire from power and allow to cool completely.
Step 2. Apply a small amount of reagent grade isopropyl alcohol to lint-free lens tissue.
Step 3. Wipe all debris, dirt, fingerprints, etc. from lens.
Step 4. Using a second lint-free lens tissue, wipe off any alcohol residue.
3. Service and Maintenance
For all other service and maintenance issues, please contact your local Showline office or an Authorized Service
Center.
WARNING! Disassembly (other than as described herein), alterations, unauthorized service, etc. will void the
product warranty. Contact your local Showline office or an Authorized Service Center for technical support and
service.
Sh wline
Installation & User's Manual
Special Cleaning and Care Instructions
43
Advertisement
Table of Contents
