Installation And Set Up; Power Requirements; Connecting Power; Connecting To The Dmx512 Network - Philips Showline SL eSTROBE 130 User Manual

Installation & User's Manual

INSTALLATION AND SET UP

1.

Power Requirements

The SL eSTROBE 130 LED Luminaire operates on AC input voltages from 100 to 240 VAC.
WARNING! This luminaire does not contain an ON/OFF switch. Always disconnect power input cable to completely
remove power from the luminaire when not in use.
AC Power Operation
When connected to an AC source, the luminaire operates on 100 to 240 volts AC (+/- 10%, auto-ranging). The
luminaire contains an auto-ranging power supply. Each luminaire can draw up to 130 Watts.
2.

Connecting Power

Direct connection to a AC power source using an AC input cable.
3. Connecting to the DMX 512 Network
Basic DMX512 installation consists of connecting multiple SL eSTROBE 130 LED Luminaires together (up to 32
in "daisy-chain" fashion. A cable runs from
luminaires)
connector on the
the first Luminaire to a DMX connector
Figure 3: SL eSTROBE 130 LED Luminaire DMX512 Input / THRU Connections
Installation and Set up
6
Table 1: SL eSTROBE 130Voltage (VAC) vs. Current
Voltage (AC) Total Current (A)
100
110
120
130
140
150
160
170
first SL eSTROBE 130 LED Luminaire. Another cable runs from the other DMX
on the next SL eSTROBE 130 LED Luminaire (or DMX512
Rear of Unit
DMX512-A / RDM
Input Connector
Voltage (AC)
1.30 180
1.18 190
1.08 200
1.00 210
0.92 220
0.86 230
0.81 240
0.76
the control console (or DMX512 control source) to the DMX
SL eSTROBE 130 LED Luminaire
Total Current (A)
0.72
0.68
0.65
0.62
0.59
0.56
0.54
connector on
device to be controlled).
DMX512-A / RDM
THRU Connector
Luminaire