KVH Industries TracVision HD7 Installation Instructions Manual page 32

Continued
C
Step 2 - Set Up the Receivers
Follow the steps below to configure the non-
SWM receivers.
DISH Network/Bell TV Receivers
Follow the steps below to run one Check Switch
test on each connected receiver.
NOTE: Once the receivers are set up, you can switch
satellites as needed using the ACU buttons, web
interface, or TracVision iPhone/iPod touch app.
a. Ensure the antenna has an unobstructed view
of the sky.
b. Using the receiver's remote control (and a
connected television), go to the "Point Dish/
Signal Strength" screen (press MENU, 6, 1, 1
on most receiver models).
c. Choose Check Switch, then press SELECT.
d. Choose Test, then press SELECT.
e. Wait up to 5 minutes for the test to complete
and the receiver's Program Guide to load.
TIP: Once complete, the Check Switch displays the
current satellite, followed by "OK."
f. Using the receiver's remote, select the
Program Guide to ensure it has loaded
properly.
Legacy DIRECTV Receivers
Using the receiver's remote control (and a
connected television), set the "Satellite DISH
Type" to "Round."
Configuring Non-SWM Receivers
35