Table of Contents
Advertisement
Note:
The timer of this long press can be preprogrammed.
Consult your qualified technician to program the
duration required.
Sending an Emergency Alarm with Emergency
Call
Procedure:
1
Press the preprogrammed Emergency button.
2
The display shows EMERGNCY and the current zone or
channel. A short, medium-pitched tone sounds and the
LED blinks red momentarily.
OR
An invalid tone sounds, if the selected channel does not
support emergency.
3
Your radio enters the Emergency Call state when:
You receive your dispatcher's acknowledgment. The display
shows ACK RCVD.
OR
You receive no acknowledgement. The display shows
NO ACK.
OR
You press the PTT button while in the Emergency Alarm
mode.
4
Press and hold the PTT button. Speak clearly with the
microphone near your mouth.
5
Release the PTT button to end the transmission and wait for
a response from your dispatcher.
6
Press and hold the preprogrammed Emergency button until
your radio exits the Emergency Call mode.
Note:
The timer of this long press can be preprogrammed.
Consult the qualified technician to program the
duration required.
37
English
Advertisement
Table of Contents
