Overview Menu - Bosch CS5800iAW 180 MCP Operating Instructions Manual

Inverter
Located in the outdoor unit and enables the speed of the compressor to
be controlled based on the heat energy demand in each case.
Setback phase
A period during the time-controlled operation involving the setback
operating mode.
Time-controlled operation
The heating system is heated in accordance with the time program and
switching between the operating modes occurs automatically.
Operating phase
The heating operating phases are: heating and setback. They are
depicted by the symbols and
The operating phases for DHW heating are: Comfort, Eco and Eco+. A
temperature can be set for each operating phase (except for Off).
Frost protection
Depending on the type of frost protection selected, the outdoor unit is
switched on if the outside temperature or room temperature falls below
a certain critical threshold. Frost protection prevents the heating system
from freezing up.
Desired room temperature
The room temperature to be achieved by the heating system. It can be set
individually.
Default settings
Values saved permanently on the control unit, which are available at all
times and can be reset as necessary.
Heating phase
A period during the time-controlled operation involving the heating
operating mode.
Parental lock
Settings in the standard display and in the menu can only be changed if
the parental lock (key block) is switched off.
Mixer/mixing valve
Assembly that automatically ensures that DHW can be drawn from the
draw-off points at a temperature no higher than the temperature set on
the mixing valve.
Normal Operation
In normal mode, automatic mode (the heating system time program) is
not active and the home is steadily heated at the temperature set for
normal mode.
Reference room
The room in your home where the remote control is installed is the
reference room. The room temperature in this room acts as the control
variable for the assigned heating circuit (which can include several
rooms or the entire house if only one circuit is present).
Switching time
A particular time when the heating temperature, for example, is
increased or reduced. A switching time is a component of a time
program.
Temperature during an operating phase
A temperature that is assigned to an operating phase. The temperature
is adjustable. Refer to the explanations about the operating mode.
Flow temperature
The temperature that the heating water in the heating circuit retains from
the heat source through to the radiators or the underfloor heating system
in the room.
Pre plumbed cylinder – 6 721 852 929 (2023/04)
.
Hot water cylinder
A DHW cylinder stores large volumes of heated potable water. Sufficient
hot water is available at the draw-off points (e.g. water taps) as a result.
Time program for heating
This time program ensures automatic switchover between the operating
phases at defined switching times.
12

Overview Menu

This chapter contains an overview of all menu options. Only the menus of
the installed modules and components in each system installation are
shown.
Main screen
– Menu
– Language
– Time of Day
– Date format
– Date
– Auto. time switchover
– Time correction factor
– Suppress warning sound
– Brightness
– Display off after
– Installer contact data
– Internet
– Standby mode
– Key block is activated.
– Deactivate demo mode
System
– Settings
– Alternating operation
– Time prog., add. heater
– PV system
– Smart grid
– Heat pump status
– Statistics
Heating circuit 1
– Season switch HC1
– Auto
– Heating
– Cooling
– Heating off from
– Cooling on from
– Display time program HC1
– Heat. mode HC1
– Off
– Manual
– Auto
– Desired room temp. heating
– Time program
– Heating curve HC1
– Cooling mode HC1
– Desired room temp. cooling
– Heating
– Heating off from
– Display time program HC1
– Heat. mode HC1
Overview Menu
19