Label And Compliance Information; Test Modes And Additional Testing Requirements; Additional Testing, Part 15 Subpart B Disclaimer; Mechanical Installation - Elatec TWN4 MULTITECH 3 M User Manual

For more information, refer to the related product data sheet or other relevant technical documents.
3.8

LABEL AND COMPLIANCE INFORMATION

Refer to Chapters "Compliance Statements" and "Integrator and Host Requirements" for detailed label and compliance information.
3.9

TEST MODES AND ADDITIONAL TESTING REQUIREMENTS

No specific testing method has been defined by ELATEC for TWN4 MultiTech 3 M.
TWN4 MultiTech 3 M has been tested and found in compliance with the specifications noted on the approval certificates and other
relevant approval documents. However, the integrator is still responsible for any additional testing and authorization process required
for the end product.
It is recommended that the host product manufacturer installing the modular transmitter perform some investigative measurements to
confirm that the resulting composite system does not exceed the spurious emissions limits or band edge limits (e.g., where a different
antenna may be causing additional emissions). Detailed information regarding test procedure is described in the relevant rule parts
(refer to Chapter "List of applicable rules").
3.10

ADDITIONAL TESTING, PART 15 SUBPART B DISCLAIMER

TWN4 MultiTech 3 M is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant, and the host
product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter
grant of certification. In addition, the final host product still requires Part 15 Subpart B compliance testing with TWN4 MultiTech 3 M
installed.
3.11

MECHANICAL INSTALLATION

The reader module can be fixed into the host device with 3 screws M3.
© 2023 ELATEC GmbH – TWN4 MultiTech 3 M integration manual – DocRev01 – EN – 07/2023 Page 4 of 13