Label And Compliance Information; Test Modes And Additional Testing Requirements; Additional Testing, Part 15 Subpart B Disclaimer; Mechanical Installation - Elatec TWN4 MultiTech 3 M Integration Manual

3.8

LABEL AND COMPLIANCE INFORMATION

Refer to Chapters "Compliance Statements" and "Integrator and Host Requirements" for detailed label and compliance information.
3.9

TEST MODES AND ADDITIONAL TESTING REQUIREMENTS

No specific testing method has been defined by ELATEC for TWN4 MultiTech 3 M BLE.
TWN4 MultiTech 3 M BLE has been tested and found in compliance with the specifications noted on the approval certificates and other
relevant approval documents. However, the integrator is still responsible for any additional testing and authorization process required
for the end product.
Refer to the KDB Publication 996369 D04 Module Integration Guide of the FCC Office of Engineering and Technology (OET) for
detailed information about test modes and additional testing requirements for the host device.
3.10

ADDITIONAL TESTING, PART 15 SUBPART B DISCLAIMER

TWN4 MultiTech 3 M BLE is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant, and the
host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular
transmitter grant of certification. In addition, the final host product still requires Part 15 Subpart B compliance testing with
TWN4 MultiTech 3 M BLE.
3.11

MECHANICAL INSTALLATION

The reader module can be fixed into the host device with 3 screws M3.
3.12

ELECTRICAL CONNECTION

3.13

PROGRAMMATION/SOFTWARE INTEGRATION

n/a
© 2021 ELATEC GmbH – TWN4 MultiTech 3 M BLE integration manual DocRev1 – 09/2021 Page 5 of 9