Spektrum AR6410L User Manual page 9

5. If you entered bind mode correctly, you will see a solid LED within about 10
seconds. You should now be bound to the transmitter and have full control and
function.
IMPORTANT: After Binding
Once the system is bound, the transmitter should always be turned on first and
then the receiver to prevent the receiver from re-entering bind mode. If your recei-
ver inadvertently enters bind mode, simply unplug the battery from the receiver and
reinstall with the transmitter remaining on.
Advanced Programming Features
The following programming features are only recommended for advanced radio
users. To safely accomplish advanced programming feature changes, please enlist
the use of a helper; one person to hold the aircraft to prevent unintended flyaways,
and a second person to make the changes on the transmitter. The procedures
below apply to all compatible transmitters. Prior to making any advanced
programming feature changes it is necessary to:
Computer Radios like the DX6i, DX7s
1. Choose an empty model location
2. Select model type ACRO
3. Perform a model reset
4. Set all channels to normal reversing
5. Ensure a successful bind has been established
NOTICE: All changes made in advanced programming must start with the receiver
powered down to prevent the motor from running unexpectedly.
Reversing Servos
Servo reversing may be achieved using the servo reversing function of your
transmitter, or as certain advanced applications require it, you may reverse the
actual servos by following the instructions and diagrams below.
Reversing The Servos on the Receiver Board
This feature reverses the servos at the board level, making it useful for
implementing features (such as elevons) when using transmitters with limited
programming options.
Sticks must be held in this position while the transmitter is on and the
receiver is off.
1. Ensure a successful bind was completed
2. Turn transmitter on
3. Move THRO stick to full throttle position
4. Move control sticks to the corresponding position for the servo to be reversed
(see illustration).
5. While holding this position, plug the battery into the receiver; power on receiver
9
EN